Textile Testing Equipment

1, The instrument adopts touch screen display, the interface is simple and easy to understand, easy to operate.
2, Linear guide rail sliding, DC motor drive, PI control algorithm speed regulation, so that the instrument runs smoothly, low noise.
3, This instrument runs with infinitely variable speed regulation, and the customer can set the speed freely according to the test requirements.
4, Users can set the required working mode according to the need.
5、Self-editing mode can set the counting value of pilling and pilling at the same time.

Mount sample and abrasion material on the fixture of machine, add specified load and test sample at specified stoke and speed. Inspect abrasion condition after testing a certain of times, or test the times of sample rubbing off to assess sample abrasion resistance property and surface pilling situation, so as to provide reference for improving fabric craft.
Install sample on fixture of instrument with adding a certain of load, and under predetermined stroke and speed, use standard abrasion materials(such as wire mesh, carborundum, etc) to rub sample at specified times so as to check its color changing situation.

To mark, print and Shrinkage ratio measurement for various textiles during shrinkage testing.

1.Pneumatic cylinder and controller equipped with instrument to support stable operation.
2.500 N digital force gauge come with instrument to catch the peak force value.
3. Units of N, kgf, lbf can be switchover.

1.Maintenance-free operation with easy to clean surface.
2.Both heater and bath chamber are made of corrosion-resistant stainless steel.
3.No angle in bath chamber, easy to clean.
4.The standard stainless-steel bottom plate, helps prevents direct contact by accessories and tubes to heating element and sensors.
5.Drain valve makes emptying of bath water fast and easy for cleaning and moving.

Except for the following products, cloth, paper, leather, etc. are suitable for testing by this equipment.

1.Test chamber case made of SUS 304 stainless steel material.
2.Tempered glass door equipped for easy observation during testing process.
3.Flame height measuring device provided.
4.Come with standard stainless sample grips.

Machine 2mm cold plate powder coating, CNC bending and laser cutting molding
New touch screen control system
One-button timing device, convenient for recording test data
Advanced and convenient test circuit, fully in line with standard test requirements

1, High configuration of hardware: 7 inches TFT Color Capacitive Touch-screen Display; Bluetooth 2.1; Concave Grating.
2, With reflective and transmissive spectrum, accurate Lab value, good to calculate color formula and do precise color transmission.
3, Built-in temperature sensor to monitor and compensate the measuring temperature to ensure the measurement more precision.
4, Independent light source detector, continuously monitor the condition of light sources to ensure the light source reliable.
5, Multiple measurement modes: Quality Management Mode, Sample Mode; Meet more users’requirement.

Used to test the cleanliness of down feathers and their products.

1. Color touch screen control, user-friendly operation is simple and convenient.
2. AC motor and synchronous belt drive, stable and reliable, low noise.
3. Fully transparent plexiglass test chamber for easy observation.

1. Color touch screen control, user-friendly operation is simple and convenient.
2. AC motor and synchronous belt drive, stable and reliable, low noise.
3. Fully transparent plexiglass test chamber for easy observation.